The Connected Duration section of the Client Behavior Analytics Dashboard displays widgets that give statistics about the average duration of client sessions.

The Connected Duration pie chart provides the distribution of the session duration across four predefined time windows:

  • From 0 to 10 min

  • From 10 to 30 min

  • From 30 to 60 min

  • From 60 to 120 min

  • More than 120 min

The Connected Duration table gives an overview of all sessions that occurred in the selected time range interval. For each historical client session, the following attributes are displayed:

  • Device Name - The client Device Name

  • Client IP v4 Address - The IPv4 address of the client, if applicable.

  • Client IP v6 Address - The IPv6 address of the client, if applicable.

  • Client MAC - The MAC Address of the client

  • Device Type - If determined, the Device Type of the client. (e.g: Mobile, Computer, ...)

  • Session Duration - The Session Duration

  • Session Start Time - The date on which the Session has been started

  • Session End Time - The date on which the Session has been stopped

  • Device OS - If determined, the Operating System of the client’s device

  • AP IP Address - The IP address of the Access Point to which the client is associated

  • AP MAC - The MAC address of the Access Point to which the client is associated

  • AP Model - The model type of the Access Point (e.g., OAW-AP1221, OAW-AP1251, …)

  • AP Name - The name of the Access Point

  • AP Version - The Version set in the Edit Device page of the Access Point

  • AP Location - The physical location of the Access Point connected to the client.

  • Portal Username - The username used to connect to the portal.

  • 802.1X Username - The 802.1X user name is configured for the client, if applicable.

  • Auth Type - The Auth type used by the client (e.g., WPA2_WPA, PSK, …)

  • Band - The radio band through which the client attached to the AP (2.4GHz or 5GHz).

  • Channel - The working channel of the client

  • Mode - The connection mode (802.11n (2.4G), 802.11n (5G), …)

  • RSSI - The Received Signal Strength Indicator of the client 

  • Rx Total - The total number of bytes received by the client from the Access Point.

  • Tx Errors - The total number of errors sent by the client

  • Phy Rx Rate - The physical receive rate of the client.

  • SNR - The Signal-to-Noise ratio of the client 

  • Associated SSID - The WLAN to which the client is associated

  • Tx Total - The total number of bytes sent by the client to the Access Point.

  • Phy Tx Rate - The physical sending rate of the client

  • BSSID - The BSSID is the MAC address of the Access Point (WAP)

  • VLAN - The VLAN through which the client accesses the network.

  • Site Name - The Site Name

  • Live Time - Client idle time (ins)

  • Tx Packets - The total number of packets sent by the client to the Access Point.

  • Rx Packets - The total number of packets received by the client from the Access Point.